MATERIALS HEALTH, SAFETY AND ENVIRONMENTAL SHEET

Preparation Date: 09/01/06

Product Name: FUSION TAPE™ For Further Information Contact: Telephone Number (713)977-4100

Producer's Name: InduMar Products, Inc. Address: 3355 West Alabama Suite 110               Houston, Texas 77098 Office: (713) 977-4100

Section I. Product Identification and DOT Requirements

PRODUCT NAME	CHEMICAL FAMILY	CHEMICAL NAME	FORMULA
FUSION TAPE™	Synthetic elastomeric tape	Not applicable	Compound

Section II. Hazardous Ingredients

Not a hazardous chemical as defined by the OSHA Hazard Communication Standard CFE Title 29 1910.1200

Section III. Physical Data

Boiling Point (°F):                   Not applicable Vapor Pressure (MM Hg):        Not applicable Vapor Density (Air=1):            Not applicable Solubility in Water:                 Nil

Specific Gravity (Water=1):             1.15 Percent Volatile by Volume (%):      Nil PH:                                              Not applicable Evaporation Rate (BuAC=1):            Nil

Section IV. Fire and Explosion Hazard Data

Flash Point:                           Not applicable Flammable Limits:         LEL: Not applicable                                    UEL: Not applicable Flammability Classification:   OSHA: 111B                                          DOT: Not regulated Extinguishing Media:    Foam, dry chemical, CO 2

Special Fire Fighting Procedures: Do not use water except a fog. Self-contained breathing apparatus with a full-face piece operated in pressuredemand or other positive pressure mode is required for firefighting personnel. Usual Fire and Explosion Hazards: None                                                   expected

Section V. Health and Hazard Information

Symptoms/Effects of Overexposure:   Tape is normally non-irritating to the skin. Ingestion of the compound is highly unlikelyand the compound is expected to have a low order of toxicity although no test data is available. Thecompound may be mildly irritating to the eyes. The compound is essentially non-volatile and shouldnot provide an inhalation hazard. Ingestion: Due to the nature of the product there is no inhalation hazard. If vapors from moltenor burning material are inhaled, move to fresh air and treat symptomatically. See physician. Skin: Normally non-irritating. If rash develops or irritation persists, see physician. Eyes: If eye contact is made and irritation develops, contact physician.

Section VI. Reactivity Data

Stability: Normally stable. Hazardous polymerization will not occur. Materialis combustible and should be stored away from excessive heat and flames. Incompatibility: Strong oxidants like liquid chlorine, pure oxygen or calcium hypochlorite. Hazardous Decomposition Products: Will produce fumes, smoke, carbon monoxide and various complexhydrocarbons during combustion.

Section VII. Spill or Leak Procedures

Procedures: No special procedures normally needed. Waste Disposal Method: Dispose of material in accordance with federal, state and localregulations. Before attempting clean-up, refer to hazard information listed on this sheet.

Section VIII. Special Protection Information

Respiratory:                None normally needed Eye Wear:                  None normally needed

Clothing/Gloves:                Normal work clothing Ventilation:                       None normally needed

Section IX. Special Precautions

No special handling procedures are necessary. This compound is combustible.Follow good industrial hygiene practices. NOT FOR INTERNAL CONSUMPTION. KEEP AWAY FROM CHILDREN.